Classic Mopar Forums

Looking for a two speed wiper switch for 69 Dart. Also, need 2 speed wiper motor with arm and bushing.

Hey all ! I took the Duster to the track for my B/Day. 1st time back to the Track after the frt U joint failure/ Trans Case Replacement. It wasnt all pretty today either. I have a used 360 Motor which seemed to run strong last time, but this time it was “popping” in the Headders. I made 2 passes, (Knowing it wasnt right) grabbed a timing light and found allmost 50 degrees of timing and the timing mark bouncing about 20 degrees +/- So the Timing Chain is done. Any Suggestions of chain makers so…

I was leaving for work and someone left a flyer on my Dart about a show this Sunday the 28th. it is in redwood city @ seaport ct. launch area. it looks like its for all a-bodies including V8’s. contact: john @(650) 343-2236. donation $5.00.

I’d like to relocate the springs on my 68 Cuda to the frame rail so i can run wider tires but I also want to run tailpipes. I’ve been underneath looking at it and it looks like I’d just have to do some fancy bending to bring the tailpipes outboard about 4″ to run down the area the springs originally occupied but without the springs actually relocated I’m just guessing.

Does anybody here have there springs relocated to the frame rail and are running tailpipes? If so what size pipes are they?…

I have a drop plate for my CARTER carb but it wont fit on my holley carb does anyone know why it wont? or if i need to buy a different one?

I have a set of TTI Early smallblock headers up for grabs. I had them on my Dart project but decided to go with fenderwells. They are coated inside and out. They have a few small scratches but it’s darn near impossible not to get scratches when installing these. I will also throw in the correct Powermaster starter that you need to run these headers. The headers will also come with the reducers and instructions. I am looking at $650.00 for the complete package and I’ll share the shipping. I will…

I have a set of TTI Early smallblock headers up for grabs. I had them on my Dart project but decided to go with fenderwells. They are coated inside and out. They have a few small scratches but it’s darn near impossible not to get scratches when installing these. I will also throw in the correct Powermaster starter that you need to run these headers. The headers will also come with the reducers and instructions. I am looking at $650.00 for the complete package and I’ll share the shipping. I will…