Category: Electrical & Ignition

Incorrect fuel gauge reading.

I am one of the many struggling with inaccurate fuel gauge readings. The vehicle is a 69 Coronet RT. I have thoroughly tested the wiring and gauge. Key on, remove the wire at the sender the gauge reads empty. Ground the signal wire and the gauge re…

61 Dart Seneca Steering Column/Turn Signal Issue

I noticed the turn signal lever keeps popping out of place and I have to pull back on the handle to reengage it. The spring clip also moves up on the two posts and nearly falls out with repeated movement. I see the flat part that seems to touch the steering wheel hub but when I put it on and tighten the castle nut a bit there’s a huge gap. I can imagine the hub is the thing that keeps the lever part always pressed onto the turn signal slider but I don’t want to tighten the hub like crazy…

Read more

1966 Chrysler 300 Power Window Problems

Do the motors come out by removing two bolts or are they spring loaded and therefore, I would need to remove the entire regulator? Are the motors grounded by the body of the motor itself or through one of the wires? Is there a way to remove the switches without cutting the wires? I don’t think my switches are making contact. Not sure how to repair the switches. Thanks!

3 flashers?

I have 3 flashers on my 69 Superbee, 1 under dash, left of the steering column, 1 right side of steering column.
The third, a smaller diameter flasher, under dash, next to glove box. The first 2 i know are for signals and hazards, whats this smaller 3…

Tach no workee.

I recently had to replace my never used new Autometer Ultralite tachometer. Just started the car-no tach? What am I missing? I checked all continuities, The fuel pump speed control, tach, and Fast 2.0 all are tied to the MSD tach output. Only the tach …

Refurbished rallye dash, now no fuel, temp, oil pressure gauges!!!

1969 Superbee Rallye dash, was removed, cleaned, new gage backgrounds, painted needles. All lamps removed, contact areas cleaned, all new lamps installed.
Before all this, everything worked, all 4 gages, even the fuel gage worked! Now— only voltag…

Am Radio help

I am a novice when it comes to radios I need some help understanding the ohm raings on the original equipment. What ohm rating speakers should I use if I am using an original AM radio? Can I put three in dash speakers and two rear speakers with an am s…