Classic Mopar Forums

1972 Dodge Dart Swinger
I started the restoration with the end goal of building a Dodge Dart Swinger that Dodge never actually built. I wanted it to look like a 340 car, but I wanted to keep the numbers matching 318 V-8 and automatic transmission. It started life with quite a few factory options, for example, front disc brakes, vinyl top, fender top turn signals, PDB, and electronic ignition. Here’s the story.
I bought this rust free California car with only 84,756 miles showing on the…

A-Body Bucket seats with tracks, spacers, and nuts. Tracks are in near perfect condition and the seats will need to be recovered. I do believe these are out of a 1974 Duster. The backs are soft sided and seat release on both seats work perfectly. $450.00 Shipping will be calculated by zip code. Pease email or call 775-867-2686.

Brand new never installed Rocky Mountain Dash A-11 Dash with Heat, Radio and (70+ Glove Box Cover). Unit is in perfect condition. $650.00. Shipping will be calculated with zip code. Please email or call 775-867-2686.

This goes along with my other post, same car, same project, same dream..

Is it possible to swap a front clip? There is some rust on my original car and was wondering if the fender walls (is that what they are called in the engine compartment) can be swapped? Are they spot welded in or should I just work with what I have and just cut replacement patches as I need them?

I know at this point most of you are wondering why I am cutting up a solid car to save a rusted car, but the rusted car’s…

I am looking for 10.5 inch flywheel 130 tooth.
Please email me if you have one!

Thanks…. :cheers:

Ok so as some of you know I am working on 1966 Barracuda that I was just going to do some minor work and get it on the road. Well that has changed a bit so now it leads me to the next question. I have seen and read quite a few posts regarding replacing floor pans, front and rear but what I am wondering is how hard is it to replace the entire floor pan from front to rear including the hump and all? The reason being is that the original car is an Ohio car with quite a bit of undercoating and rust…

What can someone tell me about a Dart Lite? Have a friend at work with one parked at his parents. A ’76’ with a slant and manual on the floor. Sounds very interesting.