Classic Mopar Forums

4 live streams give it time to load..

http://www.maroonspoon.com/wx/ike.html

.

Got a 360 for an A-body but need an oil pan. I have 2 360 oil pans but does it need the little indent on the one side in the center just ahead of the sump to help clear the steering bar? I see oil pans on Ebay advertised for 71-80 360’s are they all the same? I replaced one for a 318 A-body once and it had the indent. Any advice?

Looking for a set of front body wheels that attach to the holes of the front bumper mounts. This holds the front end of the car up when the K member…

…. gauge blues!

Sorry tech question!

I got my new Autometer MCX series gas gauge installed and of course it isn’t reading correctly with the amount of fuel in the tank. The gauge comes with a sending unit but it is the type that needs to be installed vertically. The sending unit reads 248 ohm empty and 31 ohm full. In the instructions it states that the gauge has to have a 240-33 ohm sender. Now with my stock sending unit I have 12 ohm full and 8.95 volts with the key on. I have not…

Hey guys, I’m looking for a complete AND REASONABLE A-body bucket seat/console setup for my 72 Dart. It is a bench seat interior auto on column right now. I have a console & shifter, but need buckets, console brackets, steering column, & rallye dash, etc to do conversion.

If anyone is interested, I have a 5.9 Magnum engine & OD trans from a 96 1 Ton van (100K miles) to trade. I have everything for the engine. Complete throttle body to pan, manifolds, y-pipe, converter, wiring…

Looking for the following parts for my 72 Demon:

Complete gauge cluster or just the bezel
Heater control face plate/bezel
Radio face plate/bezel

Parts must in good condition with nice chrome (not yellowed). PM or Email ryan_340@yahoo.com

I need only the metal fratzog triangle, not the complete one.

Sample:…