Category: Exhaust Systems for your E Body Mopar

Hi Members,..

Came up against a new issue when working on my exhaust system….’70 Challenger, 426 Wedge. Manifold casting numbers are Left: 2951865 / Right: 2899879. Car was originally equiped with a 383/2 barrel. Exhaust pipes are 2.25 dia purchased…

Hi guys,
I am looking into a set of ceramic coated headers for my 440/auto 73 Challenger. I am looking at the Hedman Elite ultra duty. They are a thicker walled tube and I like the design of the tubes across the flange/ spark plug access and the ball t…

Can anyone tell me the type of fastener at the back-side of the heat riser?

The two front fasteners are short studs with nuts, and these screw into the exhaust manifold. But I believe something belongs in the back, affixing the lower part of the heat…

I used 1/2" bigger material to sub frame my Challenger. I need to exit the exhaust to the side. Cannot exit rear due to Jaguar rear end will not let anything larger than 1 5/8" through it. Have full length headers ,want to use X pipe to a sin…

Been researching mufflers for the last 8 months or so as it is one of the last items on my project checklist. Just picked up these Borla crate mufflers. If you havent’ seen the video from several years back, i’ll post it below. Now I don’t know that…

Seen some good reviews on these ceramic coated headers but wanted to make sure before i buy em for my 73 challenger with 440 engine swap,thanks

looking to upgrade my headers to 5209
383 4speed
anyone know if I’ll have any clearance problems?