Category: Exhaust Systems for your E Body Mopar

exhaust manifolds or headers

michael bucklew April 6, 2024

put headers on my ’71 Challenger small block. the ends of the pipes were tight against the torsion bars on both sides. no air gap at all. friend gave me some manifolds–part #53010187 left and 186 rt side. are these good bad or ugly. I know its a matter or personal preference….Suggestions wanted—thanks, Michael ’71 challenger

Header Removal

KennyCuda March 27, 2024

Need help again with my 70 challenger 340 it has headers I bought it like that and now want to put the original exhaust back on. Since I didn’t install them I wanted to know are they removed from under the car or from the top. If from under do have to part of the front end out ? or the starter?

TA Mufflers

KennyCuda March 4, 2024

I took the exhaust down on my TA today and saw numbers on the mufflers 305 22840 was wondering if they are the original mufflers in there. Im the 3rd owner and the guy before me owned it 45 years

Exhaust question

HYDRO January 15, 2024

Needing to replace my complete exhaust system on my 73 340 rally challenger from the manifold back, I’m in the process of restoring so not running yet, has any one experienced accurate exhaust systems and was wandering if they are worth the $1600 any s…

Header/Ground Clearance

Fishgutz November 26, 2023

How much clearance can I expect to gain if I switch to a set of TTI’s? Right now there is 3-1/2” between the bottom of the flange the ground.
This is a ‘70 Cuda, 383, 727, QA1 suspension up front. Hedman Elite Series are in it now.
Any advice is greatl…

Any images or factory drawings of cuda exhaust heat shields?

mmissile October 28, 2023

I’m looking for the shop manual drawings or pictures on cars, of the muffler heat shields for a 70 cuda, and how they’re attached.

Thanks….Mike.

Header studs?

JKCuda October 15, 2023

Ok, am I blind or does no one make a polished header stud kit for the small block? I’m getting ready to install my TTI headers finally and they only came with bolts, no studs for the water jacket holes. I searched hi and low but can’t find anything st…