Category: Engine, Trans & Driveline
71 B body Dana experts
Hello,
Late last year I swapped out my 83/4 for the correct Dana 60 for my 71 GTX. After installation, we noticed that the flange on the passenger axle was bent. The seller provide another axle but this one came with a press fit bearing and no adjust…
1967 clutch hard to push in
I had the 383 rebuilt & now the clutch is very hard to push down. The clutch, pressure plate & throw out bearing are all new. Could something be binding up? Releasing the clutch is very hard & the car lurches forward. Thank for any help.
727 band adjustment with trans in the car
This is a ’70 torqueflite with radiator mounted trans cooler. I just changed the fluid, set 1st/reverse band with a 5/16" square plug socket, and changed to a deep pan with drain and filter extension spacer. All that is good and it runs good, I …
Ford 9″ as a replacement for 8 3/4
Hey all,
I’m looking to upgrade my 8 3/4 for something stronger. I’m afraid I’m going to destroy my 8 3/4 while dumping the clutch on the dragstrip.
I know Strange has a great S60 setup but I like the option of having the removable gear sets.
Speed…
help me ID this drive shaft…… 68 R/T 4 speed?
I have a few drive shafts in my shed, and they all look alike after a while…….. pretty sure this one came out of a Coronet R/T 4 speed car, but I need confirmation….
55 inches center to center…… looks like the back end was replaced;
What can cause drone APART FROM exhaust?
My 440+6 has this horrible drone, drives me mad, it goes straight into my brains!!!
It happens at lower RPM (can’t say when since I don’t have a tachometer) but driving around 30/40mph.
I can certainly say it’s not the exhaust since I snapped mufflers…
Correct PS mount for 67 GTX with AC and TRW pump.
I’ve realized after 20 years of ownership that I’m lacking the back-side bracket on my PS pump. It’s mounted with just the front bracket piece. It has a TRW pump. I’ve found several 66-69 bracket sets for the 440 with TRW pump like the one below fro…