i have a remanufactured 318 that i pulled heads off to check pistons and deck height ,pistons 030 over flat top 4 releif, never run, i measured deck to piston .065 in the hole? was hoping a little less from what i'm reading, but is this typical of 318 magnum?, block date is 1995,was looking to make some more horsepower out of block ,stock magnum heads rebuilt,I cc'd heads they were 63 cc,would like to use them and put new springs on ,need reccomendations on cams,gaskets, and possibly mill heads, keep lift under480- 500 or to 512? duration 260 ish lobe seperation 110 108 looking for good street combo with 904,323-355 rear, have pro comp magnum intake, going to run electric fuel pump, I have read alot of posts just can't figure it out , any ideas, thanks
