I have a belt alignment issue due to mismatched pulleys, I do not know where the pulleys came from, when I got my engine someone had already been playing games swapping parts (mismatched crank and rods, etc.) :banghead:
I don't know if it makes any difference from small to big block, mine is a 440. I need either one of the following pulleys:
2 groove water pump pulley, should measure 2 3/8" to 2 1/2" overall depth (measured laying flat on a table with a straight edge across the fan mounting surface)
3 or 4 groove crank pulley, from the back of the grooves to the mounting surface (snout) should measure close to 1 3/8".
Please be nice, I don't have deep pockets. Shipping would be to 98284. PayPal only.
Thanks in advance,
- Steve
I don't know if it makes any difference from small to big block, mine is a 440. I need either one of the following pulleys:
2 groove water pump pulley, should measure 2 3/8" to 2 1/2" overall depth (measured laying flat on a table with a straight edge across the fan mounting surface)
3 or 4 groove crank pulley, from the back of the grooves to the mounting surface (snout) should measure close to 1 3/8".
Please be nice, I don't have deep pockets. Shipping would be to 98284. PayPal only.
Thanks in advance,
- Steve