Duster Hood
1970-1972 Duster Hood<>Has 2 Hood Pin Holes<>No Rust.
I am in N/E Ohio And [u]CANNOT Ship[u]
E-mail me at scnpc2912@roadrunner .com
OR Phone (330)274-2912
Asking $150.00 obo
Thanks,Sam:glasses9:
Poor Man’s Rear JIG
I’m trying to weld my Axle Tubes, and yes I’m trying to pinch pennies where I can to help save for that “GAS” that the Dart will eventually be sucking down. Is there a way to get the tubes aligned for welding without spending a small fortune on a Jig?
One idea I had was to a length of pipe, or perhaps tacking on angle iron onto the individual tube sections, to hold them in alignment, and then welding up the seam. I could then cut the tacks, and finish the weld. Also, would leaving the…
volt gage reading??
At an idle my volt gage reads to the negative a bit but when I increase the idle the volt reading goes positive, am I not charging correctly? Belt is tight and no slipping.
Time for a younger Admin.
Climbing over the peak of that hill Joey! 41…downhill the rest of the way. Happy birthday to all six of you today!