Hi everyone new member as of today. Let me start of by saying that im from cleveland ohio. My car is a 73 340 duster i have had this car about ten years and have quite a few things done to it such as Motor bored 40 over one piece crank stock. eagle I beam rods srp pistons redone heads 2.02 / 1.60 manley streetflow valves 3 angle job hardened seat bronze guides whole valvetrain is comp cam .507/.510 lift 240/246 duration one piece pushrods roller rockers 8 quart oil pan high flow oil pump edelbrock torker2 single plain manifold 750cfm edlebrock carb stock ignition cam is hydraulic flat tapet. electric fuel pump. Trans is a fresh stock 727 tci stall converter 2800 two coolers deep pan. Rear is 8 3/4 poisi 4 11 gears bfgoodrich drag radials with line locks bnm short throw shiffter and the trans does have a shift kit everything else as far as suspension and interior except for the shifter and couple gauges is stock setup.the fastest ive ever goten the car is 13.20 in the quarter I thought for sure when i was building that engine it would be a 12 second car in ten years still not there yet. Bought this car right when i got out of high school all the mechanical work done by me. (im a tech at a chevy dealer) Any way the problem im having is my key broke off in my steering column i snapped it cuz ignition tumbler froze up that key also worked the locks on the doors. Trunk has seperate key. Im just looking for something quick n easy to fix this as i dont have the money for a fancy steering colum just yet. A nd no i dont have a spare key i no that is stupid to say but thats how it is. Im thinking just get a new cylynder n key but the steering column is probably the only thing i have not had apart on this car its a column shift but i dont use that shifter. how do i go about geting the cylnder out of the column with the key stuck in (and it will not come out) and any recomendations where to get a replacement? sorry 4 the long introduction
