Category: Mopar Drivetrains

I was thinking of using a SMR transmissions reverse manual valve body and super comp rebuild kit for my 904 trans build; but haven’t heard much about them has any one used there products and if so what did you think of it? Any info or oppinions on building up a 904 to handle alot of 1/4 mile abuse f

Dear Moparfreaks,

I have a “84 Ramcharger 4×4. My Tranny shifts up smoothly, however in the reverse it slams into. I am afraid that band will break soon. I have installed a new rear servo assembly and adjusted the rear band.(72 lb In,2 1/2 turns back) I have disassembled the valve body, cleaned and

What parts do I need to rebuild a 904 to handle the torque and horse power that my 408 will produce?

I have found a great buy on a rebuilt 440 with flat top pistons and want to put it in my 1961 Chrysler. Up until now, I have been told that the older cast iron (1961- “B” Block) transmission will not bolt up to the crank on the 440. The guy I am working with is pretty sure it will.

Any comments?

I’m just trying to find some information on where to get or what carb to buy for the 360 “Early 360” I’m putting in my 63 plymouth fury. The issue I’m going to run into is finding a carb or linkage for the Carb for the 727’s kickdown linkage. Any help would be greatly appreciated.

Thanks,
Dan

has anyone ever put a sm block chevy in a 65 plymouth valiant where could i get the motor mount kit and which headers would fitwhat about a clutch pedal setup so i can run a 4-spd , also power steering and dis breaks for the front (keep budget in mind)i have the small block avaiable if the will work

i need a automatic shifter cable for my 65 273 valiant with the shifter in the floor i cant find any auto parts store that has it,also who would be a good vender to find parts for these cars………thanks mike :confused: