Category: Heating / Cooling / AC

Trying to figure out what the heck this part is. It’s a vacuum switch of somesort in the heater hose I know, but can’t locate one anyplace. Any ideas where to find it? Mine is broken

About to install the Hayden 2947 clutch and wondering what others have used for the mounting hardware?
Are locking washers necessary on the clutch to water pump pulley bolts? Or is it OK to use flat washers and some blue loctite on the threads?

All buttoned up after the removal of the stereo, ashtray assembly, heater controls and glove box.

I probably wouldn’t have had to remove all this, but I had some electrical sketchies that I wanted to deal with while I was in there anyway.

The Classic…

As I work on timing chain, I will replace heater hoses. They were routed just off the engine hanging toward exhaust manifold. I could shorten a bit so they sit nearly on valve cover, or extend out toward the inner fender. Thoughts please on somet…

As I work on timing chain, I will replace heater hoses. They were routed just off the engine hanging toward exhaust manifold. I could shorten a bit so they sit nearly on valve cover, or extend out toward the inner fender. Thoughts please on somet…

We have 40 degree AC now.
Due to it being 50 degrees here and wind blowing it was a little tricky, but not because of the system.

For one, it was slow taking coolant because of the ambient air temp, but other than that it went like one would expect of…