Category: For A Bodies Only

Free to a good home. I have just got finished pulling the last of the parts out of the Dart. So I have a Front Bench Seat, 225 Engine & 904 Transmission (both only had 47,000 miles on them (factory). The Engine is still on the chain and Hoist. So if you want them, please come get them. I’m located in Delaware Country, Pennsylvania. Call me to arragne a pickup. (610) 613-9129.

Pat

Anyone on here from michigan going to the mt clemens car show tommorrow?

If an engine is undertimed, i.e. timing is 7 BTDC but ideally it should be at 14-16 BTDC, would the engine run warmer or be hard to start?

I am in need of a adapter plate to use a GM Turbo or Powerglide behind
my 474 B engine. I just bought an engine with the gm flex plate and crank
adapter on it but need the plate that goes with it. Its TCI and its a combo
adapter plate and rear motor plate. Anyone know of one availble:bootysha:

My email address is hbear4hw@yahoo.com

Thanks,
Roy

I have purchased a 413 motor out of a motorhome. The front pad is stamped 413 ht. Does anyone know what the ht stands for. The motor is from a 73-74 vehicle. Any info. on horsepower or compression or general info. about these type motor. All input appreciated.:read2:

the dome light (68 gt dart)??? cant get the light to turn off ,checking the grounds tonight

I have a decent used fuel tank that came from a 1975 Duster. It is in good shape, had gas in it when it was removed and had no signs of leaks. Included are the attaching straps, J-bolts and nuts, the stock 5/16″ fuel pickup line and sending unit, the pad and the filler tube and rubber trunk seal and screws. There are no vents on this tank, just the pickup/sending unit. I’m looking to get $30 plus shipping for everything.

I also have from the same 75 Duster, the trunk lock parts minus the lock…