Category: Electrical and Ignition

I haven’t put a timin light on the dart in 5 years.Forgot what the initial timin should be.I have a racin mopar dist. Vacuum plugged off. 360 484 purple cam Rpm intake. 650 double pumper.360heads w/some work. TTI exhaust.2800 stall.I rmember I was able to get the car to idle around 800-900 rpm.now it idles at 1100-1200.wants to stall at the stoplights.I have not wrenched on this car in years.I now have a 16 yr old son who wants to start workin’ on the dart.HELP PLEASE.

brand new switch in the coloum left turn is fine and right turn is fine front and back.The issue is if the turn leaver is not in the right spot the rear tail light stayes lit if I move it a little goes out.I dont want people thinking I have a left turn light out.what gives is there a fix.dam aftermarket parts.

I have installed a MSD 6AL box and ss coil in my 66 Dart with factory mopar elec. dist.I have the car running,but when I go to turn it off with the key,it stays running?In the instructions,they call this run-on.It says to put a jumper wire on the dual ballist on one side and little red wire on the top and run a ground to the bottom on the other side.Has anyone tried this with good results?Thanks,any help would be great!

P.S 360 LA engine

I just bought an MSD Dist for my small block to replace my old DC Tach drive Dist and when I went to install it I realized the rotor is not lined up with the bottom of the dist shaft correctly.

If you line up the bottom of the shaft at 12 O’clock and 6 O’clock the rotor is pointing towards 2 O’clock on the MSD but on my DC, and an old Unilite I have sitting here and the 3 stock distributors I have lying here the rotor points towards 12 O’clock or basically the same direction as the paddle at…

just updated my charging system with a nippendenso 120 amp
alternator not finished in the pic
man what a upgrade volt gusge does not move at all while at idle

I’m restoring a 1971 Barracuda that I originally bought in pieces.
Needless to say, after many months of sorting, cleaning and painting
parts,…