Author: Tirekickertoo

Hello, I have an opportunity to buy a pair of 340HP exhaust manifolds. The owner said that they were from a 1968-60 A-body car. One manifold has part number 2863552, the other is not legible. Initial research said that this part number will fit a 19…

Hello,

I have a chance to buy an original drivers side front fender for a 1972-1974 Dodge Challenger. Is there a stamped manufactures part number on this fender? If so, where can I find it? Please send picture of the location. How could I dec…

Hello,

Question, I have a small block (318) A904 TorqueFlight automatic transmission made in early 1970. I also have a small block (340) A727 TorqueFlight automatic transmission made in mid 1971. Are the transmission fill tubes and dip stick…

Hello,
Would someone send me pictures of the position of the inner and outer tie rod ends as they are connected to the drag link. I found a drawing in the shop manual but want to see a better example of this. Also are the tie rod adjusting slee…

Hello,
What is everyone using using for upper control arm bushings? I have a 1971 Challenger with factory upper control arms. I want to install MOOG K7103 eccentric/offset bushing but can’t seem to get them to press in without pushing/tipping to…

Hello, I have a connection that has few manual transmissions for sale. What are the identifying casting numbers or other characteristics I should be looking for in a 4 speed manual transmission? My contact may also have other manual transmission part…

WTB, Looking for a Challenger passenger door belt line trim piece in good condition. I’m also looking for the hardware that attaches all four pieces. Not sure if the hardware is reproduced at this time?

Thank you,

Tirekickertoo