Author: coupe32
intake manifold exhaust crossover
It has been a long time since I posted on here. Sad that this forum is seldom used anymore. A question if anyone should reply is this:
I’m going to use a 7176 Edelbrock Performer RPM intake on a 340 engine. Can I use the fel pro intake gaskets #1213 to block the exhaust crossover. These gaskets…
intake manifold exhaust crossover
It has been a long time since I posted on here. Sad that this forum is seldom used anymore. A question if anyone should reply is this:
I’m going to use a 7176 Edelbrock Performer RPM intake on a 340 engine. Can I use the fel pro intake gaskets #1213 to block the exhaust crossover. These gaskets…
3/8″ NPT port for temp probe switch/small block
I have an Edelbrock air gap intake manifold on my 340. Currently running an electric fan without a relay. Want to use a relay harness and threaded probe switch. I have only one 3/8″ port on the intake and I am using it for the mechanical temperature sending unit. Anywhere I can put this temp…
3/8″ NPT port for temp probe switch/small block
I have an Edelbrock air gap intake manifold on my 340. Currently running an electric fan without a relay. Want to use a relay harness and threaded probe switch. I have only one 3/8″ port on the intake and I am using it for the mechanical temperature sending unit. Anywhere I can put this temp…
need early s/b timing marker
Trying to find a timing marker/tab bracket that bolts to the timing cover under the water pump on early 65-68. Any timing marker of those years of 273’s, 318’s or 340’s will fit. This is for the early timing covers with water inlet on the drivers side and timing tab on the passenger side. They…
Which starter?
I have been using a 17084 mopar mini starter on my 340 engine. I bought this starter in 1999 and it is making a loud grinding noise a few times and not engaging until about the 3rd or 4th try. The starter has worked well until now and I was going to replace it with another. Someone suggested I…
Aftermarket AC on 340
I have been thinking about installing AC in my streetrod. I am running a 68 340 engine with single belt 68 pulleys and the cast iron water pump. My question is can I adapt this 340 to a Sanden compressor using stock Mopar small block pulleys? If so which pulleys will I need? I know there are…