Author: carfreak6970

Hello Folks!

So I need some help. I have the trim that runs along the top of the fenders, doors and quarters for a 67 Dart GTS, as well as the rocker trim. I stripped them of their anodizing and polished them. Well now comes the time to install t…

Hello,

I am looking for the cross shafts and spider gears for an 8 3/4 power lock type sure grip. I cant seem to find them anywhere and the internal parts kit that Doctor Diff offers is out of stock…

thank you.

Hello Folks,

I have a funky gauge issue on a 70 charger that I am hoping to get some insight on.

So the car has brand new wiring and a new instrument cluster circuit board. All gauges worked as well as these factory gauges do but a couple months a…

Hello Folks,

So I am in a pickle, yet again!!! I got a drive shaft made for my 67 Dart GTS and according to Brewers website, a 67 big block A body should have a 30 spline output shaft. So I got the drive shaft made with that slip yoke and a 30 spl…

Hello,

I am working on a 67 Dodge dart and noticed the sockets in my reverse light assemblies are toast.

View attachment 1715663748

Im sure finding 67 reverse light housings are either expensive or impossible to find (but if you have them…

Hello Folks,

So this past weekend I was finally able to break in the 440 for the 70 Charger my old man and I are working on. So my dad is very old school and sadly the term "cant teach old dogs new tricks" resonates very well with him… …

Hello Everyone…

So this past weekend I tried to install my master cylinder in a 67 Dart. The master cylinder is the 7/8 bore from a 75 Dart.

The push rod I had was an adjustable one from Mopar. However it was way to long!! the overall length at…