Author: 73Coupe
Console pics
I am looking for some of your console pics, installed in car.
In particular, I am curious as to how the carpet glued onto the sides at the front drapes down and over the floor carpet….
Just finish the "resto" on mine…
Exhaust Hanger Accessories
1. Dual exhaust LH side hanger bracket that mounts to the body. The hanger mounts to this. see photo below.
2. Wire clamp for hanger (need two – circled in photo). I already have the hangers.
I was going to make them but would save me time if someone had some spares laying around….
3. Also, need a rear tailpipe hanger at the tip (one).
Car: ’71 New Yorker, so any fuselage era parts should work.
Thanks…
1. Tailpipe hanger BRACKET…
Rust-salt crust removal
Removing rust from the body structure crevices where the body to stub mounts are. This area is semi-exposed and this became filled with road debris. Since the car lived its life in SASK and Alberta, I assume it was exposed to a few rounds of salt. Not …
New Dual Exhaust
Well, I’m finally going to be putting duals into my NY’er this January. I looked at all the threads where y’all talked about this subject previously. I looked at TTI and Waldron’s.
TTI is in stock for about $700, Waldron’s is about 10 weeks out for ab…
1962 300 4-door Hardtop (not mine)
On B a T. Located in my town…. current bid $2900
No Reserve: 1962 Chrysler 300 4-Door Hardtop Project
1971 Chrysler Emissions Sticker (Federal) #3577749
Looking to see if anybody on here has a need for the above named emissions sticker, pictured below. Located on the LH inner fender, below the cruise control and master cylinder.
I am speaking with a vendor (Performance Graphics) who has the artwork an…