I decided to finally swap out my /6 Torsion bars for a set of 890's I picked up last year. I made my own removal tool from some angle iron and after doing all the normal preparation it worked fine for the passenger's side but when I tried it on the driver's side the bar wouldn't budge no matter how hard I pounded.
Finally I got the bright idea of wrapping one of my motorcycle tie downs around the bar in front of my little tool and hooking a comealong to the tie down and and another tie down I put over the rear and in line with the torsion bar.
All it took were a few clicks and the bar popped right out. Think I'll do that right at the beginning next time -- it was almost too easy.
Finally I got the bright idea of wrapping one of my motorcycle tie downs around the bar in front of my little tool and hooking a comealong to the tie down and and another tie down I put over the rear and in line with the torsion bar.
All it took were a few clicks and the bar popped right out. Think I'll do that right at the beginning next time -- it was almost too easy.
