Up for sale is a set of U heads, they are the same as the J heads. They have approximately 1 hour of run time in the garage. They were completely redone. They had a valve job and new 2.02-1.60 Ferrea stainless valves installed and new bronze guides put in. Some of the valves were cleaned and some weren't. They have a number scribed on them as to which chamber they go back in. The heads have been milled some. From the info I have seen the heads usually come in around .715" to .727" when measuring the chamber depth. These come in around .693". Depending on your block your intake might have to be milled to get the intake to sit properly on the heads. I was not happy with the milling that was done around the valve guides to install the Viton seals. Look at the chipped away spot around the guide. That iron should have been milled all the way to the guide. Your local machinist would be able to handle this job easily. I cc'd the heads and they check in at 65 cc's. Intake ports were gasket matched only and the exhaust ports were smoothed all the way through, not ported. I had issues with the engine these were on and decided to go with a set of aluminum heads this time around. If you have any questions at all, don't hesitate to ask. I am asking $150 + shipping. Click the link below for pictures.
http://s248.photobucket.com/user/jai...?sort=3&page=1
http://s248.photobucket.com/user/jai...?sort=3&page=1
