As I understand it, the engine/tranny tilt angle and the pinion angle should be equal, i.e. the two axis should be parallel and the U joint operating angles should not exceed 3 degrees ideally.
That all said, I see mopar enthusiasts using some pinion angle (preload?) to account for the rise of the pinion under load. That is, put the pinion angle a bit below parallel to the output shaft so that when it rises under load, it becomes parallel to the output shaft or close to it. Some in...
Read more
That all said, I see mopar enthusiasts using some pinion angle (preload?) to account for the rise of the pinion under load. That is, put the pinion angle a bit below parallel to the output shaft so that when it rises under load, it becomes parallel to the output shaft or close to it. Some in...
Read more