Electric Choke Question
Just so you dont think I did not try to search for the answer, I did, I am Planning to actually connect my electric Choke on my holley 670 SA. I do not have a ballast resistor, and I am running MSD. Where should I hook up the Choke?
Also I have been running the car for the last couple weeks, without the Choke Wire connected. Will this effect performance, or fuel economy?
Need help finding 71 Dart rocker trim clips
Hey All:
I’m looking for some clips for my 71 dart. I’m trying to find the pieces that hold the “hockey stick” lower stainless rocker trim molding on.
Any help, or even a pic of the correct clip is GREATLY appreciated.
thanks
Steve
A little “off topic” question for you great electrical guys ???
I know this is an A body forum, but hopefully one of you guys can shed some light on this for me, and you’ve never steered me wrong yet..
We run class 8 trucks, with Detroit engines and have been having a NIGHTMARE with alternators the past couple months …
After 3 years, one of the stock Delco alternators crapped out .. We installed a new after-market one and it was fine for a few weeks, and then it started WAY over-charging – up to 16 volts …
Since then we have tried 3 different re-man…
Steering Extension Shaft
I am replacing a leaning tower of power for a V8. I have power steering but will convert to manual….for a while, until I want to drop the 800.00 on the TTI headers. Anyone know where I can get the extension shaft they make so I can use my steering column that is in the car? Thanks.
Need Some Help here to find someone!!!
Do any of you guys know this guy 451 Jim??
He is a Moparts Member
Posts: 2567
From: Lexington Park Maryland
Registered: Dec
I need to get some info from him on some part numbers!He worte some posts on how to put roller bearing in the 727on moparts!
Thanks,stan
PS I did a search on him on moparts but nooooo luck!:(
Bypass hose for Edelbrock Magnum intake to old style pump
Anybody use the Edelbrock 7577 Magnum Air Gap Intake and the LA style water pump? What bypass hose do you use? The standard LA bypass hose can be forced into place by trimming it down, but ends up somewhat twisted/kinked.
gm tech question, sorry…
im working on a weird issue at work and wanted to pick the brains of any tech that might be on the site… i have an 01 pont grand am 2.4 L im trying to cure a check engine light issue on. its throwing an evap code 0440. i believed the vent solenoid to be bad, but the code returned after i replaced it. normally this would end up being something silly like a loose gas cap or a stuck vent solenoid. when i smoke test the system, the vent solenoid checks out fine. i am not finding any other leaks,…