Classic Mopar Forums

Has anybody ever used this kit from AR Engineering? They sell an alternator bracket that will allow you to use a “Toyota Interally Regulated Alternator” ?

Thanks for the HELP…I’m new to Mopars.

_*Application:*_ 1967 barracuda originally a 273 car. Now has a 360 with a 2-groove water pump pully and a 4-groove crank pully. No power steering but would like to add aftermarket a/c sometime in the future.

_*I also had a question on how to wire this up? It only talks about 2 wires *_
1) Post…

I am doing a little cleaning . I have the following parts for sale. All parts are in Melrose NM 88124.

B&M deep aluminum 727 pan great condition $50 plus shipping

1 set of 67-76 A body defrost vents black really nice $20 shipped

Aluminum 2 bbl slant 6 intake $20 plus shipping

Thanks!!

For you folks in the Castle Rock Colorado area, or anybody else looking for a nice 1966 Coronet 500 2 door hardtop, here’s a very nice project car…

Well Guys and Gals,

I wanted to give everyone on this forum a huge THANKS!

I never expected the forum members to rally around the cause as they did.

To recap…

I was looking for a CARTER AFB top for my Barracuda, because on the last turn of the last screw, of my rebuild, the screw on the top half of the carb for the step up piston cover broke the internal casting.

I have a Direct Connection style K Member for sale.

This is the K Member that allows you to install a B or RB engine in your A Body car. It uses the 73 and newer style spool mounts. Factory location is used.

This K Member has been notched for the oil filter and for the driver motor mount. A fresh coat of industrial strength rust proof black paint has been applied and is ready to install.

The cost is $325.00

I also can supply the motor mounts needed for this K Member for an additional $80.00

This sale is for the 11″ drum brakes found on most B Body Hi Performance cars. These can be used on your B Body to upgrade from the smaller 10.5″ brakes or for your A Body to replace the brakes with the big bolt pattern type.

Included is the backing plate, the drum and everything inside. These were removed from a running donor vehicle. The drums, pads and wheel cylinders should be inspected.

To complete the change over to the big bolt pattern you will need to replace your rear axles to the…

I have for sale: Mopar A Body Big Bolt Pattern Disc Brake Conversion pieces including the Upper A Arms.

Here are all the parts needed to convert from the small bolt pattern on the A body cars to the bigger 4.5 x 5 bolt pattern. The needed parts included are: The Upper A Arms, Spindles, & Caliper Adapters as well as the following parts that are easily found at your local parts supplier: Lower Ball Joints, Rotors and Calipers. These are from a 1974 Dodge Dart.

All you will need to supply is the…