Tail Panel formula S
Once again I need your help. I am trying to find the correct red color used on the tail panel for a ’69 barracuda formula S. It’s black with two red stripes. Let me know the name and/or paint code.
Thanks again, Art
rubber for bumperettes?
Aloha!
Anyone now where I can get the rubber for the front bumperettes on a 71 duster?
Should I ask this in the parts wanted?
FABO member you are a great wealth of info. !!!! Thanks for your help in the past and even more in the future!!!!
MAHALO:cheers:
Ssi
After retiring, I went to the Social Security office to apply for Social Security. The woman behind the counter asked me for my driver’s license to verify my age. I looked in my pockets and realized I had left my wallet at home. I told the woman that I was very sorry, but I would have to go home and come back later. The woman said, ‘Unbutton your shirt’. So I opened my shirt revealing my curly silver hair.
She said, ‘That silver hair on your chest is proof enough for me’ and she processed…
Video of my 65 plymouth
Hi Pete Walton. Here is a video of my 65 plymouth i was telling you about in your post. This was when i had the M1-tunnelram and 2 750 edelbrock carbs on it.This was shot at my home track. the frist pass was a 1/4 mile pass and the second one was a 1000 ft pass. I was fighting a bad cross wind that day because my car usely runs 8.60 in the 1000ft. I just wanted to show you this vid so you could see that tunnelrams do work good. I hope you are anybody that watches it likes it.thanks Mopar658)8)
…
71 duster bolt pattern?
I have a 71 duster that had a 340 in it and has front disc brakes and a 8 3/4 in the back. I have measured the bolt pattern and looks to be 5X4″. Is this correct? Any ideas on the largest tire 15″ I can fit in the rear wheel without moving the springs and what backspacing? Thanks
Starter relay?
I have a 71 duster 440 4spd. Turning the ignition switch to the start position does nothing, but if I turn it to the run position and bypass the starter relay and run a hot wire to the positive terminal on the coil it starts right up and runs find after I remove the hot wire to the coil. I have a yellow wire which is hot when the switch is turned to the start position. The yellow wire is plugged to one of the two spade terminals on the relay (which I just replaced) If I jump the yellow wire to…