What Combination U-joint needed?
I have a 727 trans and a 9 inch rear. I have the piece that goes into the transmission and the drive shaft that came with the 9 inch. I am going to have shaft shortened and reuse it .What combination u-joint do I need to be able to work with the 727 slip yoke?
Just a test
Trying to upload a video of my 66 Dart. Ok tried a few things and not too sure what I am doing wrong
Dash frame 70-76A-Body in blue
Have a real clean dash frame that will fit any a-body from 70-76 in blue. No dash pad though. $125
Email me at: fastfrankie_98@yahoo.com
Located in southern NJ by Philly
Low mileage PS Gear/pitman arm
Came out of a low mileage 71 Swinger around 55,000 miles. $40 Email me at: fastfrankie_98@yahoo.com
Located in southern NJ
14×4.5″ Stock Rims SBP – Nice – Free shipping to Nats!
I have a set of low mileage 14″x4.5″ wide small bolt black steel rims. $50 for all four. Email me at: fastfrankie_98@yahoo.com
Located in southern NJ by Philadelphia
mags
Have been running a mag on my race motor this year an it seems to eat tachs. Have already went through 3 an have talked with autometer to make sure all is right. Ran msd in the past with no problems. Has any one else had any problems? I am running it in a aluminum race boat an was wondering if it might have something to do with the ground?
Friday carlisle pics
Here are some pics of carlisle on friday. Great weather & crowd. Was the best bargain hunting expedition i’ve had there yet.
Oldschoolcuda