Max Wedge throttle cable
In need of a Max Wedge throttle cable for max wedge intake. If anyone has one PM me here . Thanks..:yes:
cast or forged stroker crank?
im building a 340 stroker, im looking at scat crank/rods, diamond pistons, custom ground cam, ported eddey heads, tunnel ram ,2-660s carbs. 6800 rpm red-line, is any one running a cast crank with 550-560-575 hp? i had my mind set on a cast crank, replies welcomed.
Trim restoration needed 68 Cuda
I Finally got all the trim off the Cuda , Soon its off to the body shop 🙂
I need to have some of the trim polished , and some have a small ding or two.
I don’t have a show car but then again , the good paint will make the trim really stick out .
I’m looking for suggestions on a place to take them to , preferable south west Ohio or somewhere kinda close ,
I could drop them off at a show or something .
Any referrals guys ?
Need a header suggestion!!
I have a 440 going into a 1966 dart. This is strictly a race car so I’m looking for some 2″ headers. I know TTi makes them for the 67 and up cars but I havent been able to find any for my 66. Any help would be appreciated.
What Gear ?
I just replaced my speedometer cable with a new one. It didn’t have any gears on the end of it, but now my speedometer shows about 15 to 20 miles faster than it is. What tooth of a gear do I need ?
Thanks Dan Image: http://www.forabodiesonly.com/mopar/images/icons/icon5.gif
Tips on install of new woodgrain on console
Can anyone give me a tip on how to straighten or flaten the peal-n-stick woodgrain going on an Abody console? Can I iron it to flaten it out? Low temp of course…
69 barracuda front clip and hood bolts
I need bolts for the fenders, hood, front valance, and nose piece for a 69 barracuda fastback. PM me thanks