Category: Performance Talk

curious… i have the chance for a free 727 tf. out of a 75 jeep with a 258. will this work on my 360?

I’m installing a 360 in a 71 Swinger, going to use a set of summit headers, will these headers hit the PS box, i was in the process of installing MS for added clearance, but don’t feel like paying 130.00 for the PS too MS coupler, any exsperiences with the summit headers & PS.

I was just reading a few things on putting hemi heads on a 440. Does anyone know what it would take to build a B block or RB block into a hemi? Would you end up using factory 426 hemi heads, manifold, and headers? Can you do the same thing to a 383 or 400 block? Since hemis are so hard to find and…

Dang, The latest Mopar Action has a tech article that says you will just about destroy your street engine without vacuum advance. Says incomplete burning makes more carbon, which fouls plugs, causes rings to wear early, and gets in oil and ruins bearings! My MSD distributor with my MSD 6AL box does…

Hello,
I´m building a 408 stroker from a 78 360 block, with a scat rotating assembly (forged pistons, I-beam rods, cast crank, balanced set scat 1-98112BI). Heads will be mopar w-5 with a roller cam. Expected output is 500hp at the flywheel. This will be a street engine, reliability is a major…

Hi, does anybody know of a sending unit for a fuel cell that will work with the stock gauge in a 70 Cuda? The closest I can find is 0-90 ohms, I believe the stock gauge is about 7-96 ohms. Is 0-90 close enough?

I’ve been away from the site for awhile, I fired the thread on my build back up in the…

help needed w/my 7272 in my ramcharger it has stopped pullin in drive and 2nd just slips,it will go just fine if i pull it down in low(1st) and it changes out fine ,kickdown works ok ,reverce is okwhen i come to a complete stop it just slips til i pull it back to low and shift it manualy,I can slow…