Category: New Hemi Swaps
clutch pedal to master linkage
Here is some pic’s–Not the neatest but works like a charm
5.7 hydrolic throw out bearing
Hers is what I use for my throw out bearing–Steve
Hum You guy’s are in trouble now
GOT THE RE_SIZING TO WORK now Question—- I set my re-sizer to small should i do a custom size???? If so what should I set it at??? Thanks Steve
running the MSD 6-Hemi ?
If you could go back and start over, would you do it again ?
i have a 2005 5.7 truck motor still in the crate thinking about doing a swap in a Chrysler i have :idea1:
5.7 Hemi install
Guy’s I have my reservations about the bottom ends on the 5.7’s but after coming across a smoking deal I picked up a complete 2005 5.7 from starter to A/C compressor, wiring harness, PCM, 545RFE guy bought it off Ebay back in November 2009 for $3750 and I just bought it today for $1100.00 I am installing it into a 69 Charger Daytona clone, I am a member over on B bodies only aand they said this was the place to ask what I need to do, it came out of a 2005 Rumblebee, I know the trans tunnel…