Category: For E Bodies Only
Clutching slipping
hi guys
So I getting slippage on my clutch at hard throttle at 3500 rpm, I’ve put 2 new clutches and still same thing. At normal speed it works fine, if I can’t figure it out I’m going back to auto which I hate to do
440 and msd eletronic ignition
HELP!!!! I’m doing a ground up restoration on a 71 Cuda. It has a 440 6 barrel, and
switching the ignition to an MSD. I’m looking for information on how to
modify the wiring harness? Or to replace it with one suited for the modification.
I also understand that some modification has to be made for the Rally dash
tachometer to function. I’m getting close to installing the engine, and want to…
1971 Cuda Gilled drivers side fender
1971 Cuda drivers side Gilled Fender.
Minimum rust. Some dents that were filled.
Must pick up in Horsham Pa. Which is near Philadelphia.
PM me for pictures. $400
Thanks
Tom
View attachment 21716
…
1971 Cuda Gilled drivers side fender
Vented gas cap, 73 Cuda
I believe the gas caps I’m buying from Stant are not correct. The fit is lacking a “tight seal” and not properly sealing. There is no rubber to metal seal I think. It is NOT a locking gas cap as I want to go stock. BUT…it seems there is only the Stant cap to fit. Can anyone tell me IF there IS a vented, NON-locking cap for this Cuda?
Thanks, Mike
70 Chall rag resto finally
Hi fellows finally getting around to finishing my 70 chall rag ( purchased 25 years ago) not a numbers matching car however I am building it my way 340 6 pak auto (B5 blue with a blue int and white top factory) I am planning to run a T/A exhaust I have all the parts and an idea but just not sure exactly where the tip hanger brackets locate on the car so if possible any advise or pictures would be appreciated ( my FSM)doesn’t show anything on a T/A Exhaust )…
1971 CHALLENGER “DEPUTY” SEAT FRAMES ARE THEY PLYMOUTH?
Hi guys, I’ve got a 1971 Challenger ‘Deputy’ with the factory Barracuda interior… My question: I’m putting a 1972 Challenger interior in it now (with the 72 thicker style seat foams etc) BUT it appears the seat foam for a 1972 sits differently on the springs than a 1971?
Are my front seat frames Plymouth? – were Challenger seat frames completely different to Barracuda? Does 1972 Challenger front seat trim fit a “DEPUTY” seat frame? Confused? Help? Thanks.
Wanted 72 cuda factory A/C vents
Hey Folks.Iam in need of the passenger A/C vent for my 1972 cuda.I have the double center vent but 1 of the mounting tabs is broken so i would be interseted in that as well !! Thanks !!