Category: Engine, Transmission & Driveline
Installing Edelbrock 1906 carburetor
I am installing Edelbrock 1906 on 1978 Chrysler 400 engine. Do install anything to do back of carburetor?
Follow up to my January post re ’71 Imperial leaking oil…
I decided to do a full teardown and rebuild even though the engine only had 45K miles on it. So, I replaced all gaskets and seals, timing gears and chain, camshaft bearings, rod and crank bearings, and piston rings. I kept everything standard size as…
Carb fuel line connector
was trying to pull TQ from my BB, but this nut seem to be super tight. I wonder if there are any pitfalls? Reverse thread maybe? It’s getting round rapidly but still not moving. Left it soaking in atf for now..
Stromberg 2BBL home tuneup tips pls? ’67 Monaco 383
Hi there, me again …
My ‘67 Monaco looks to have its original Bendix Stromberg 3-276 WWC and I was wondering if any of you had any home tuneup, adjustment advice for best performance, mpg, mixture, idle, kickdown operation, & Cold-start.
No…
The old stalling when put in gear syndrome
I have been working on my 66 383 now for about two years, with short road trials for about year and a half. So, after my recent work on replacing the timing chain and gears, I had never seen anything like the chain slop in this one…..mainly from the…
Rod Cap Reinstall Alignment
Hello all, I have a 69 Plymouth Fury 3 with a 73 318.
I had the engine pulled out to resolve rear main seal leak and decided to replace the rod and main bearings while in there. After getting everything replaced and measured with plasiti gauge I remov…