Category: Body Shop
70 cuda rear bumper
Trying put rear bumper on my 70 cuda using brackets that were on it when I bought it 2962306-307. New original rechromed bumper. But driver side curled up tried another bumper it did the same thing. Looked up original part numbers it calls for 2768604-…
Can someone measure drivers side door mount bolts to /cowl flat?
It however leaves about .5″ of space between the flat section of upper cowl/firewall/top of a pillar. I was working on clamping the replacement cowl down and there’s no way it can do down that much.
Passenger side is factory and fits flush.
This isn’t my scenario, but wanted to make sure everyone could see what I’m talking about.
Hoping someone can…
Hood won’t latch.
So I’m working on finishing up my 72 restomod and I’ve run into an issue that I’m continuing to struggle with. The hood is aligned great, closes about 98% of the way, but the striker will not fit into the latch. The latch is moved as close to the rad s…
For Sale E-body Rotisserie
Auto Lift CR 3000 Car Rotisserie set up for E bodies with front and rear brackets
1500 OBO located in SOCAL possible delivery
somerbr1@aol.com
Aftermarket (AMD) quarter panel installation adjustment
I’m currently restoring a 70challenger.
We are proceeding with the restoration mainly on the rear part, but I have a question for you all.
As shown in the photo, there is an approximately 3/16 height difference between the left quarter panel and trunk lid panel.
The quarter panel is made by AMD, and the trunk lid panel is the existing original one.
The curved line on the right quarter panel is the same as the trunk lid panel.
The left quarter panel has not yet been fixed by…
roof skin & drip rail
parts all amd , the drip rail is two piece . it appears kinda flat and doesn’t follow the contour of the roof . how’s this work ? what is the order of assembly ?
T/A QUESTION
For those of you that have a T/A is the cowl & the fender bolt area satin black or organisol black ? Also could someone show a picture of where the hood pins go on the fender. Thanks