Author: Von

$5000 TAKING OFFERS SELLING NONOP, it’s got a custom 318 (modification list below) engine needs to be buttoned up and I need to sell it to help pay some medical bills.

Only 72K DMV verified original mileage, the engine is currently needing to be comp…

71 RR, 383 auto car. I bought this car for the qtr panels 10 or so years ago. But, dont want to cut up a real RR. The qtrs on the car are very nice. Doors nice, drivers fender nice, passenger fender is creased. Good header panel, no front bumper. Rear bumper decent, will straigten and rechrome….

1. RB M1 intake, 4500 flange $125
2. Yukon Dana 60 spool, new in the box, 3 series, 4.10 and down, 35 spline $125

3. Pro Stock SB Intake, copy of a Weiand Excelerator $100 or best
4. 275/60/15 MT ET street radials, down to the wear bars, but some life left. $30

fast72beeper@sbcglobal.net or…

950HP E85 Carb. Built by Mark Sullens, all E85 specific parts, QF E85 blocks, billet base plate, etc. Nice carb, comes with spec chart and Mark’s tuning instructions.

Only selling because they quit selling E85 at the local pump for the 2nd time….sick of fighting supply issues for a street…

Comp custom grind solid roller for B/RB. This cam was spec’d by Dwayne Porter for me, but Ive changed combos. Cam has been installed, degreed and idled for about 30 mins.

266/266 .646/.646 108 Lobe separation.

CRB# 4143B/4143B R 108.0

Cost me $350, selling for $200 firm, plus shipping.

Thanks

470 low deck rotating assembly for a 400 block, 440 steel crank offset ground to 3.915 stroke, Ross flat tops pistons,.990 pin, 4.375 bore. Eagle H beam rods, 6.385 length. Assembly is electronically balanced. Ready to drop in and go. Im also including the rod bearings which are Clevite H bearings,…

Ive decided to sell my 470 rotating assembly. The assembly has about 1 hour run time on it total. Assembly has no issues whatsoever, ready to run in your block.

440 steel crank offset ground to 3.915 stroke, Ross flat tops pistons, 4.375 bore. Eagle rods. Assembly is electronically balanced. Ready…