Author: northstart

For 1970 Challenger

I started to replace the support mount for the 727 in my 70′ Challenger and noticed that it is quite a bit off-center (also found out that the crossmember is from 72-74 car and had to drill a couple of new holes but that should not matter the mount pos…

Hi,
I have 1967 TF727 transmission in 1970 Challenger. Tranny has 1-prong neutral safety switch without back-up light switch.

From various Mopar forums I learned that updating to 3-prong switch with backup lights (1969 and up) would need also new &quo…

Hi,
My1970 Challenger has not been started for >25 years. Previous owner has messed around with the wiring under the hood.
I started to go through the wiring and to test if starter motor is working or not. It is now wired as shown in the picture bu…

Hello, does anybody know what is the difference between these 1970 weatherstrips and 1971-1974 weatherstrips?
I have 1970 car but the driver’s door is probably from 1973. If I buy the felt set for 1970, will the door felt fit also to 1973 door?

Hello,
I have an original R/T hood which seems to be slightly bent down in center of the front edge.

What should be the distance of front edge center level to the corners level? The measure of blue line In the attached picture (pic is not from my car)…

I started to clean and wire wheel 70 Challenger dash frame and found this cool stamp. Frame is very likely original. Torx bit is ‘scale bar.’ Does anyone know what it is for?