Author: Muswagon
Full new wiring harness?
My wiring has been like all of them, hacked and jimmy rigged by all the previous owners.
Any recommendations for a full wiring harness?
I don’t need it to have an alternator regulator harness, I am one wire hot alternator.
I don’t need wiring for …
Spicer 5789X u joints
I am a little mind boggled…. Bought Spicer 7260 u joints, they won’t actually fit in because the ‘meat’ in the center of the joint is hitting if that makes any sense?
Does one dremel it a bit so it will clear?
It is a miniscule amount but it will …
71 Duster carpet 4 speed
Just finished my 4 speed swap, and need to install the carpet I bought from rock auto… Just their generic one but made sure it was for 4 speed… I assume the shape is different for the tunnel hump?
Anyway, need help getting my head around install. …
3/4 trans lever A body
Looking for the 3/4 trans lever for A833 NON OD trans.
This one… Brewers is sold out
Shifter rods… oy
So the trans I bought came with an old set of rusty rods that did not look correct. Last year I bought a newer set from a local guy that said was from his 71 A body, however, I did not verify just took his word because i know him and I am stupid someti…
Some snags with my conversion
The clutch pedal sits much deeper than the brake. It allows for some adjustment with a tab, but that only pushes it further down. To engage the brake light (or disengage i guess) the brake pedal sits 2" higher. Very confusing
Second, using the hy…
A833 driveshaft length?
I am going from 440/727 to 440/A833. I know the driveshaft will be too short, what is the needed?
1971 Duster, 8 3/4 rearend.
I searched but now I am dizzy as people seem to measure differently.
I have read anywhere from 47.75 to 48.96 "