Author: Juan Veldez

A little E Body **** for Sunday. Sick Cuda. Cheers.

Where does this go? I have a 73 Chally. Thanks in advance.

Pulled the plugs and noticed that 1,8,4,3 where tan-ish. Plugs 6,5,7,2 were clean as a whistle. Same goes for the exhaust ports and tops of pistons. Thought the carb primary on one side of the dual plane intake was set bad and caused this, but that’s n…

Anyone know a good source for 904 with a gearvenders overdrive? I promise I will not hammer this 340 with 10.5 comp and 3.91 gears and blow it up!

I am re-setting the valves after initial break-in and after checking that the heads are still torqued properly. It has a hydraulic lifter cam. I am tightening the lash to zero on all the valves and then will do a 3/4 turn down. This setting is supposed…

So, I had my original valve covers on the 340 for first start up (on right). Removed them to re-torque the heads (didn’t need it, all stayed put) and reset the valves (not done yet). My buddy said these valve cover gaskets are the best thing since sli…

I need two of these brackets. I have the fasteners. It’s on 72-74 Challengers. I have not been able to find any repops so I assume I need them off a donor car.