Author: jason99

I just acquired a 74 Fury III with a 400 and the passenger side trans cooling line is shot near the radiator end and ‘patched’ with some rubber hose and hose clamps. It leaks like a sieve and so far is the only mechanical problem I’ve found with the car. To that end I need to get it patched up.

I found an old thread that mentioned inlinetube.com, getdiscbrakes.com, and classictube.com as possible places that have pre bent sets. I saw no hits in their catalogs so I talked to each of them…

74 Fury III 400 – Transmission Cooling Lines

Starting a thread to show what I’m up to with my project.

Today I installed a radiator I had re-cored locally by B&L Radiator nearby in Alpharetta GA. Also installed was a new upper and lower radiator hose. The upper hose fit perfectly. The lower hose that was listed as fitting was two inches short as seen here.

View attachment 237368

There were no other lower radiator molded options so I wandered the hose isle at the parts store before settling on a Dayco Length E 71901, which…

74 Monaco Coupe Project

Since I struck out on finding anyone who makes a replacement small block radiator for a 74 I bought a used one from the only place I could find one (with no warranty on the core), www.cbodies.com for $100.

Shot of the rear of the radiator.

View…

Not mine, but didn’t see this here.

RARE CLASSIC: ’75 PLYMOUTH GRAN FURY III BROUGHAM

Looks a little rough for what they are asking in my opinion.

View attachment 216154

View attachment 216155

View attachment 216156

Look for this style of steering wheel, but in black for my 74 Monaco.

View attachment 215071

Anyone have experience, good or bad, with shipping a hood? What did it cost? I found one, but it isn’t local to me and I don’t have a vehicle it would fit in so I can’t just make a road trip out of it.

-Jason

Not mine

View attachment 210996

View attachment 210997

View attachment 210998

View attachment 210999