Author: gearheadmike

I got a 87 360 with 727 trans and it has the factory quadrajet carb and i put a new cable kickdown on it.
I got it working temp right now but do they sell a
Cable Bracket Corrector for this…

Got a 360 LA just put new bearings/rings in it. Lifters/cam are original. Engine only had 65k but bad/leaky seals so i just did a basic rebuild. This has the flat tappet hyd lifters also. Not sure…

I’m sure this is been brought up a lot but head gaskets. lol
I got a stock 360 edel intake headers that’s it. I’m engine going together and idk if i should just get a felpro kit and run it or go…

I got a 360 i’m redoing and new to mopar would like a good true Repair / Service manual for a guide. Engine’s a 74 going in a 87 so hate to buy a specific factory service manual for the 74 van.
…

I got a older 87 D250 and seen they sell the cable kit for the 727 to do away with all the linkage crap. Just like to see who here’s got them and how they like them/how hard/easy they are to…

I got a older 87 D250 and seen they sell the cable kit for the 727 to do away with all the linkage crap. Just like to see who here’s got them and how they like them/how hard/easy they are to…

Putting my 74 360 together got all my freeze plugs in and oil galley plugs except the one under the rear main cap as my kit did’t come with it (not happy)
So the oil galley plugs are

2 in front…