Author: Fireguyfire

I’ve got the dash panel out of my 67 barracuda so I can clean everything, check the switches and wiring harness, replace the bulbs, etc.
My car is an unrestored car that I bought off of the original owner this fall. The car had been stored in a Quonse…

I have been chatting in the parts wanted forum with some members who suggested I move the discussion here in the electrical forum.
I’ve removed the dash and gauges from my 67 barracuda for a refresh and a cleaning. I doubt anything has been removed sin…

I am refreshing the dash and gauge cluster on my 1967 barracuda. In taking the dash out some of the times on the back of these 2 switches were corroded and broke off and stayed in the harness connector, so I am needing a replacement wiper switch, and h…

I cleaned off the stamping on the left side of my 727 above the oil pan on my 67 barracuda 273 commando car.
The number stamping are clear but seem a bit strange to me compared to B and E body automatic numbers that I’ve seen over the years.

I thought…

I’m looking for opinions on how to proceed with a problem I have with the 273 commando engine that is matching numbers in my 67 formula S fastback barracuda that I bought recently.

The car is an unrestored survivor, and the car has been stored inside …

I’m slowly going through the mechanicals on my survivor 67 barracuda I bought from the original owner. The car had sat in a barn for 30 years or so.
I’ve gone through the rear brakes and I’m about to get into the front disc brakes.

Are there any tips …

I am needing a piece of trim for the rear of my 67 fastback barracuda.
The rear trunk fold down divider has carpet on the inside, and the edge of the carpet is covered with black metal trim (4 pieces).
I am missing the curved top piece that covers the …