Author: challboy728

Can anyone provide a definitive answer for the location dimensions and color (gold or silver) of a pentastar on an e-body fender. I installed an OEM fender on a ’70 Challenger – no mounting holes for the pentastar. (The original fender was rusted out…

I am swapping a 5.7 Gen III hemi with 8HP70 trans into my 1971 Dodge Challenger R/T using the Holley swap kits. I am at the point where I am ready to put the K-member with motor/trans up under the car.
Does anyone have any info on the transmission / …

NIB – PRW SFI Chromoly Steel Flexplate Part #1839200. Adapts 5.7 / 6.1 Liter Gen 3 Hemi to A727 or A904 Mopar Transmission. After ordering, I decided to use the 8HP70 transmission in my swap. Too late to return it when I made the decision.
List at S…

The seat tracks in my 1970 Challenger T/A were very stiff. I am having the seats re-upholstered, so I figured it was a good time to restore the seat tracks. I disassembled the 6 way seat track and found one of the zinc guides had a flange broken off….

The previous owner of my T/A brazed the distributor vacuum advance arm in place (Pictures attached). I replaced the vacuum advance unit with a similar unit. We dyno’ed the engine after rebuild, the tech at the dyno shop thought there should be a spri…

The old carpet out of my Challenger has these plastic "carpet supports" glued to the carpet. They cover the seat belt anchor points on the outside of the front seats. I have attached pics of the one on the passenger side. The parts are ver…

Not sure if this should go in electrical or interior – but – does anyone have routing description or routing pics for the antenna wire on a 1970 Challenger T/A? My antenna wire has a plug on it like it goes thru some sheet metal, has a clip on it and …