Author: bullet18

I think its a vacuum issue. Not sure its drawing fuel. Could it be the pcv valve i have hooked up? When the accelerator pumps give it fuel it revs but then dies right after.

My 70 challenger is in desperate need of quarter patches. Figured id look around here before buying whole panels from amd. The pass side just needs the front lower section but the drivers side is a little worse and probably need the whole wheel lip rep…

Im priming my 400 based 512 stroker and not getting any oil pressure while spinning the drill. Its making like a squelching noise while i do it. Do i need to turn the engine over while priming it to get oil to the sensor like with the rockers?

I was wondering if anyone else on here had 3d printed any parts for their cars. So far ive printed an fitting tools, a tpu valve cover breather seal and a throttle cable bracket. Im thinking about printing hilborn style itbs for fuel injection to run e…

When i was 16 I bought a 1970 dodge challenger rolling chassis in an auction on ebay for 2050 dollars. The person who sold it to me told me that the frame was in "ok condition". It wasnt, and neither was the floor or the firewall. I should h…

I am currently working on a 3d printed max wedge single plane. I am going to be using glass reinforced nylon filament which is strong enough and gas safe. I am trying to find a port profile to extrude for the mating surface, does anyone have a to scale…

I just got the 512 in with the new wholeshot torque converter and the bolts dont kine up at all. The pictures not very good but the t/c bolts are further up than the flexplate holes. Is there a different flexplate i need? It fit perfectly into the tran…