Author: admin

1970-1972 Duster Hood<>Has 2 Hood Pin Holes<>No Rust.
I am in N/E Ohio And [u]CANNOT Ship[u]
E-mail me at scnpc2912@roadrunner .com
OR Phone (330)274-2912
Asking $150.00 obo
Thanks,Sam:glasses9:

i need a drivers side door glass for a 1967 dart 2 dr. sedan(post car)

I’m trying to weld my Axle Tubes, and yes I’m trying to pinch pennies where I can to help save for that “GAS” that the Dart will eventually be sucking down. Is there a way to get the tubes aligned for welding without spending a small fortune on a Jig?

One idea I had was to a length of pipe, or perhaps tacking on angle iron onto the individual tube sections, to hold them in alignment, and then welding up the seam. I could then cut the tacks, and finish the weld. Also, would leaving the…

At an idle my volt gage reads to the negative a bit but when I increase the idle the volt reading goes positive, am I not charging correctly? Belt is tight and no slipping.

Climbing over the peak of that hill Joey! 41…downhill the rest of the way. Happy birthday to all six of you today!

I’m not real sure of the physical differeence in the heads for a 413 62 model heads. The compression varied depending on the motor. One was 13.5 and the other was 11. Does any of you know where one could see a pic of heads in question lying side by side, top and bottom so that i might become better educated before i start spending my money on something that isn’t the real thing. Thanks for the help guys and gals.

I know how some of you like the dog dish cap. I have 2 really nice caps and 1 that is scuffed up.maybe you lost one or need a couple extras to make a set. make me a offer .