Author: admin

just put a new painless muscle car wire harness in my 72 duster. everything is working fine except for ONE wire! It is the wire that gets hot through the ignition and goes to the ballast resistor. Using a test light it has NO power in off position as it shouldnt and in the run position the test light is very dim. when i hold key slightly further forward than run position just before starter engages it gets a nice very bright light like it should have in the normal run position? Any ideas? …

I just bought a 3/4 ton conversion van that has a 9.25 under it. Not sure if it’s a peg leg or SG at this time. Do these 9.25’s have any value and are they desireable fo any of our cars or street trucks? Lots of other stuff on it like disc brakes, OD tranny. Curious about the rear end value.
Small Block

I have a new Steele Rubber Products Windshield Channel for sale, new in the plastic. Steele Rubber Products Part # 70-2183-50 for 1970-1976 Duster.
Asking $80 US or Canadian and can arrange shipping from my home Burlington Ontario Canada.

Mod please delete this thread, thanks

All right now;getting the new rear axle together to replace the original unit in the ’64. Still haven’t found a puller to get the old axles out,and…

$3,700.00
1970 swinger orig slant 6 has 360 904 alum intake headers with 2200 stall converter 8 3/4 391 posi small bolt ralleys all new brakes door panels are kinda new new carpet. The body is a 20 footer needs a going over runs trans is good needs a shifter & a rubber brake hose to drive..Has a rebuilt 500 carb rebuilt new hoses
The car needs to be finished not road ready
Floors have been patched
HAS A LOT OF GOOD PARTS WELL WORTH IT
Mays Landing NJ
ram98sst@juno.com

Selling the front fenders off my 63 wagon. These are in very good shape but have had some patching done on the doglegs. Have some small dents that…