Author: 70rcode

New MP 515379 bare Aluminum heads for use with std 1.88" installed height, 0.060" thick spring locators & Oem rocker assembly for occasional street & 6500 rpm use….Need suggestions Valve info like Brand #, Tip length, Overall len…

Looking to replace my Short Arm Prestolite points set…Any idea where a new replacement set could be sourced at…

Back in ’72,..Cleavite “Micro” was the bearings to run in my area & I ran them in a fast limited street/ some 1/4 mi action 7500 rpm race hemi (68 S/S type tune) for a while with no Noticable abnormal wear (bearings or crank) main & rods & engine ran great ..I only knew enough to follow the gang…. Getting same engine slightly cam detuned for another go at it & wondering if the “M” is ok or is some fundamentally Wrong for Street/Strip & a H or P only preferred ?

Was always surprised & kinda disappointed that my ’65 magi Crossram intake didn’t have some provisions to attach a heat shield (similar to street hemi) to keep hot oil off the runners…. Anyone know of, seen or used any kind of heat shield & p…

I remember my 10k mile ’69 Hemi Factory Cam bearings surprisingly looking so Pitted– Erroded Bad looking in ’72…… They’ve pretty much stabilized at that first peek inspection appearance….I remember most Experienced Mopar mechanics advising &quot…

The Service Manual notes there is something Unique & Not Interchangeable with the # 1 Upper Main Bearing shell having a Special Tab side Front Chamfer for timing chain oiling ?? I’m looking over my new set of Sealed Power 119M bearings & only …

Hi all,…Need help & suggestion technique for pulling Main Bearing Caps off…. These are really wedged in Tight & I don’t want to crack anything..Help !!