Author: 70cuda50

I am electrically challenged but my mechanic is electrically savvy but we are stuck. I have Sniper with hyperspark distributor, hyperspark ignition box, and HSpark coil.(and Holley Efi tank/ in tank pump). Internally regulated, single wire alternator …

I am electrically challenged but my mechanic is electrically savvy but we are stuck. I have Sniper with hyperspark distributor, hyperspark ignition box, and HSpark coil.(and Holley Efi tank/ in tank pump). Internally regulated, single wire alternator …

I have the mopar performance big block cast valve covers with a twist on hole and knock out spot on each. I am installing a m/e Wagner Pcv valve in one of the twist on holes. It needs 3/4” id. Does anyone know which grommet with that id also has big …

I have TTI headers and am still trying to decide wire routing and boot angle. Not trying to duplicate original setup. I’ve looked at as many pics as can find. Looks like lots of people run them around front below headers vs running any over valve…

View attachment 73796

restored my heater box and installed. A gap exists between it and plastic defrost plenum that goes up to windshield. Is that gap normally open or was some sort of gasket used. Nothing was there when I took it apart but most of…

since I am already spending more than I want on resto, who doesn’t, I am going to tackle restoring my steering wheel. I have the 70 3 black rubber spokes with silver inlay, plain horn cap. I will attempt duplicating the wood grain, at least the overa…

how important are the plastic film moisture barriers inside Cuda door panels? Since panels are plastic do they really need protection like styles that have cloth or cardboard backings? I saw a thread somewhere how to make them and found a kit on web, j…