Author: 67 GTX

I am removing the 4 speed in a 67 GTX. Got everything disconnected, but just wanted clarification on where to support the engine while the trans is out.

I currently have a block of wood under the oil pan, on the sump (deeper part of it), right by wher…

Can anyone tell me if a 1967 GTX 440 4-speed with a Dana 60 had a pinion snubber on the rear end?

If yes, does anyone know where I could get one?

Hello All,

I asked about garage building in a prior thread (Garage Planning Questions) and everyone was very helpful!

I was hoping to get people’s thoughts on the following:

I am allowed 1000 square feet, and 16 feet tall at the tallest point.
I wou…

Hey Everyone,

I’m looking for some pole building garage companies that work in/near the NJ area. I’m sure that extends into PA and NY.

So far I’ve seen Fetterville and Pioneer Pole Buildings.
Anyone have any experience with them/know of any others…

Hopefully shortly I will be replacing my leaf springs, and while doing so, I wanted to detail the parts as much as possible.
I know some components were left bare, and not sure if it varied by the factory that the car was built. Car is a 67 GTX/440/4-s…

To give a little background, I rebuilt the front suspension on my 67 gtx a few years ago. Before the rebuild, the car tracked straight and the steering wheel was centered when doing so.
During the rebuild, I found that the ear on the lower control arm…

Does anyone on here have New Jersey QQ plates? How hard was the process to get them?

Also, does anyone have vintage NJ plates from the 60s? Is there a process to get them for your car?
New Jersey License Plate History Article

That article makes it se…