Author: 3rd1970RR

So, I just ordered a new Dana from Strange Engineering for my 70 Road Runner that has an 8 3/4. Does anyone know the difference in lengths of the drive shafts? Figure since the one I have is fairly new, I’ll take it in to have it shorted.

I have a 1970 Plymouth Road Runner that I am consider selling.

OK, Let me just start off by being honest up front. I am not sure if I am ready…

I have a 1970 Plymouth Road Runner that I am consider selling.

OK, Let me just start off by being honest up front. I am not sure if I am ready…

I have a set of aluminum slots for sale. Bolt pattern is 5 on 4 1/2. These are not unilug.

I’m asking $250 for them.

Attachment 159049…

I have a set of Ralleys w/tires, center caps and beauty rings I am selling. Front pair is 15×6” (I think). The rears are 15×9” that I special ordered…

I have a set of Ralleys w/tires, center caps and beautyrings I am selling. Front pair is 15×6” (I think). The rears are 15×9” that I specialordered…

I have two sets of 15″ x 10″ wide aluminum slots for sale. One set is the kidney bean style and the other set is the gasser style. They both are a 5 on 4 1/2″ bolt pattern (Ford/Mopar). Back spacing on the kidney bean is 3 1/2″. Back spacing on the gasser style is 4″. I also have a set of 15″ x 8…