Author: 1moretoy
Help with Vin Number
Hello all, can anyone help me identify if these stamps are legit. The only one I’m really questioning is the engine block stamp. It looks as though the last digit (3) was stamped twice. Other than that everything matches from what I can tell. I don’t have the build tag on the fender as the car was painted and lost at some point from what I was told. Is there any way to check the history of the car? Carfax doesn’t go that far back does it? How can I break down my vin to check the factory…
RMS street Lynx 4 link?
Hello all, I’m getting ready to start on the rear suspension and have some questions. I’m moving the rear 4 link control arms inboard with the brackets provided in the kit. I’m a little confused on the way they weld in. There is a bracket on the outboard side of the frame that looks to be part of the floor. When I cut the frame rail out this is going to go with it but do I need to replace it? The instructions I have don’t show this so I’m not sure the proper way around it.
Does the new…
Engine Bay Down Bars
Does anyone know where to get theses bars from? I’ve only found them at Magnumforce so far. I’d like to get a pair to help stiffen up the front end when I put my new suspension in.
Santa Came Early!!! Hellcat Redeye build with RMS suspension!!!
Well folks, My build journey will begin here. I received 10 boxes from Bill @ Riley motorsports a couple of days ago. I went with a complete front clip and rear streetlynx set up. 14″ 6 piston willwoods all around will be the stopping power. I can’t wait to get started on this build. Once I finish up the trunk pan I’ll get started on the suspension & motor swap. I also purchased a brand new hellcat redeye long block. Fun fact, the build date is the same as my birthday 
It will be topped…
It will be topped…
Hellcat Swap
For those that have done a hellcat swap, what harness did you use? I was looking at the Mopar performance harness kit with ECU ECT but not sure on the length. Most swaps I see the ECU and power bloCk is mounted in the engine bay. I want to mount everyt…
Trunk Pan Replacement Help Needed
Hey all, I need to replace the trunk pan and part of the extensions. The car came with a two piece pan and I’m Not sure the best way to install. I’ve never done a pan so trying to gather as much info as possible. Do you overlap the panels and spot weld…
70 Challenger Mini Tub.
Hey all, I’m going to start replacing my trunk pan this weekend and was planning to mini tub at the same time. I opted for the two piece pan kit as shipping was unbelievable for a 1 piece. They wanted $380 just for freight. I figured an extra weld was worth the savings. For some reason my tubs look like they were widened but I’m not positive. I feel like the raised area in the middle of the tubs would be smooth not raised. Can you tell me if these look stock to you.
As far as the mini tub…