Author: 1973CudaKJH

Rear Valance installation. Do I need to bend the quarter panel upwards to match the rear valance on the Cuda? Sorry about poor picture. The quarter panel is on right and valance is on the left. Looks like if I bent the quarter panel 90 degrees everythi…

Sorry if this is a repeat quest. Has anyone used the 17×9 Cast Rallye wheels and the recommended 275/40-17 tires per Classic Industries on all four wheel locations for a stock Cuda car? I have Jeep JK rollers on now, but need tires and wheels to drop b…

Does anyone have knowledge of or someone to contact that has installed a Modern Challenger dash in a vintage 73 Cuda or Challenger? I bought a Cleveland P&P Hellcat Engine and Manual Transmission with wiring harness, UConnect, steering wheel/Steeri…

Help please. I need the cowl/firewall to inner fender measurements for a 73 Cuda. Is 7-1/8" correct for outside edge of cowl to inner fender as illustrated in Cuda4 ( I saw in an earlier post)? Is 48-1/2" where the inside edge to inside edge …

I have a TR6060 Manual 6 speed from Cleveland Performance with a Hellcat engine and a Schwartz Performance Chassis. The problem is Schwartz sent me a TR56 trans mount. Rather than swap out mount they want me to buy a tail section for a TR56 and mount t…

I just received my Schwartz Performance chassis and then installed the Hellcat engine and six speed manual for Cleveland Performance. Chassis & engine look fantastic.

Waited all most 10 months for chassis. Unfortunately, I used the time for body w…

I just bought this 73 Cuda and have since disassembled and on rotisserie for a resto-mod. I have a Hellcat Engine and 6 speed Transmission from Cleveland Parts and Performance and a Schwartz Performance Chassis due to be delivered in March. Many challe…