How would you finnish the motor of a surviver car

Well guys i need your help here as some of you know i am new to your forum and i just bought an original paint 1960 Belevedere 2 Dr Ht.
As we speak my seats are out to the upholster and he is looking for the correct meteral to rehab front and rear seat's and package tray this has to be done i know.


Also i scored an rubber floor mat from one of the FL members ....... thanks !!!!!!!


My problem lies with under the hood, i have striped the 318 poly down to her short block looking for any problems and found only a bad Water pump, Timing chain and Valve seals in need of replacement.

how would you guys Finnish the motor if it were yours?



1st: ....... Just clean with soap and water keeping it all intact being very careful not to remove any existing paint.

2nd: ...... Aggressively clean all with steam jenny if i loose most of the paint too bad it was going to fall off anyway but looks a little better not great.

3rd: ...... Touch up everything under the hood not removing the motor do the best half ass job i can looks good at car show.
4th: ..... Quit acting like a baby pull the motor dissemble it hot tank it and get out the check book.



Name:  DSC_0469.jpg
Views: 18
Size:  79.1 KB
Attached Images
 
Author: Vanish